To Next Page

To Previous Page

4-Channel Digital Video Recorder

ID Button on Remote Control

Turning on the Power

Connecting the power cord to the DVR turns on the unit. The unit takes approximately 60 seconds to initialize.

Initial Unit Setup

Before using your DVR for the first time, you will want to establish the initial settings. This includes items such as

time and date, display language, camera, record mode, network and password. Your DVR can be set up using various

screens and dialog boxes.

Throughout the screens you will see

. Highlighting the and pressing the (Play/Pause) button gives you the

opportunity to reset that screen to its default settings. After you are finished with any setup screen, you can highlight

Save and press the

button to save the changes and exit the screen. If you do not wish to save the changes, highlight

Cancel and press the

button to exit the screen.

Press the

MENU button or move the mouse pointer to the top of the screen and then select (Login) in the Live

Monitoring menu to enter the setup screens. The Login screen appears.

NOTE: To assure the secure management of the system, setting up a password is strongly recommended.

NOTE: If you cannot use the front panel buttons, click the

button using the mouse to enter a password, and

the virtual keyboard displays. See instructions below for using the virtual keyboard.

Figure 4 ─ Infrared Remote Control.

If a DVR System ID is set to 0, the infrared remote control will control

that DVR without any additional operations. (Refer to the Information

setup screen in this chapter for further information on setting the System

ID.) If the system ID is 1 to 4, you must to press the

ID button on the

remote control and then press the number button (1 to 4) in order to

control that DVR. If the System ID of two or more DVRs is set to 0,

those DVRs will react to the infrared remote control at the same time.

NOTE: For simplicity, the button descriptions in this manual refer

to the front panel buttons.

Figure 5 ─ Login screen.

Select a User and enter the password by pressing the appropriate combination of

Camera number buttons and then the

button. There is no default password when

logging in the admin user for the first time.

ADT 4-channel DVR User Manual

Questions and Answers: