User’s Manual
14
NOTE: When the S.M.A.R.T. displays Bad, the screen displays a message box. Once the “Bad” message displays,
replacing the hard disk drive is recommended, usually within 24 hours.
NOTE: Temperature and S.M.A.R.T. information will be available only for internal hard disk drives supporting
the SMART (Self-Monitoring Analysis and Reporting Technology) monitoring program.
Shutdown
Highlight Shutdown in the System menu and press the button. The Shutdown screen displays asking you to confirm
whether or not you want to shut the system down.
Figure 14 ─ Shutdown screen.
Network Setup
Figure 15 ─ Network menu.
Network
Highlight Network in the Network menu and press the button. The Network setup screen displays. You will be
able to change the Network, LAN, DVRNS and WebGuard settings.
Figure 13 ─ Storage Status setup screen.
The Type column displays the type of storage device.
The Disk Bad column displays the percentage of bad sectors.
Not formatted indicates the device is not formatted.
The Temperature column displays the temperature of the
storage device.
Good – The temperature is normal.
Bad – The temperature is 70
o
C (158
o
F) or higher.
N/A – The DVR cannot read the temperature.
The S.M.A.R.T. column displays “Good”, “Bad” or “N/A”,
depending on storage conditions.
Good – The storage condition is normal.
Bad – Data cannot be written on or read from the storage
device.
N/A – Storage conditions are normal, however, the S.M.A.R.T.
monitoring is not working or supported.
After selecting Shutdown and pressing the button, a screen will appear telling
you when it is safe to disconnect power.
To Next Page
Loading...
Need help?
General
