IST Series UPS (10kVA-200kVA)
User Manual 3 Installation
33
During moving, it needs to operate by two people (one at left side and one at right side) to
avoid tilting or human injury.
----End
IST7 series UPS (160kVA-200kVA)
Step 1 Check if the package appearance is in good condition and if there is any damage caused by
transportation. If damaged, please inform the carrier immediately.
Step 1 Transport the UPS to assigned site.
To avoid tilting during transportation, keep the UPS centre of gravity at the centre of forklift
arms and keep the forklift arm go beyond the wooden bracket.
Step 2 Unpack the external package, remove the foam pad and plastic bag, and take out the
accessories.
Step 3 Check the UPS.
Inspect the appearance of the UPS and check if there has any damage caused by
transportation. If any damage, please inform the carrier immediately.
Compare with the packing list and check if the accessories mode is complete and
proper. If the accessories lack or model wrong, please take note and contact the our
company or local agency of our company.
Step 4 Dismantle the bottom cover plates (as shown in Figure3-8), and unscrew the bolts that fasten
the UPS and wood bracket, and then remove the bolts (as shown in Figure3-9).
To Next Page
Loading...
