EasyManuals Logo

AGFA CR Series User Manual

AGFA CR Series
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #265 background imageLoading...
Page #265 background image
DD+DIS170
.11E
Installation Planning
123
DOCUMENT CONTROL NOTE:
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
3.2 Guidelines for Placing the Digitizer
Observe following guidelines for the installation place of the digitizer:
ï‚· Recommended table height: 75 cm
ï‚· Due to the workflow* of the system it is recommended to install digitizer and
NX workstation close together.
* The operator has to go from digitizer to the NX workstation and back to the digitizer for each
scan cycle.
WARNING:
The device is a table-top digitizer. The structure and stability of the table used need to
be suitable in relation with the size and weight of the system. Do not use excessive
force when inserting cassettes in the digitizer as the device may slip or drop off the
table. Use a non-slip-mat below the digitizer or other anti-skid measures. The table
should not be subject to excessive shock and vibrations from other sources, as this
may disturb the operation of the digitizer.
Edition 1, Revision 1 CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 11 / Page 11 of 24
03-2013 Type 5151 / 100 / 110 / 200 / 210 Agfa Company Confidential

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AGFA CR Series and is the answer not in the manual?

AGFA CR Series Specifications

General IconGeneral
TypeComputed Radiography (CR) System
ResolutionUp to 10 pixels/mm (depending on model and image plate)
ConnectivityDICOM
ApplicationsGeneral Radiography, Mammography
Laser TypeSolid-state laser
Power Requirements100-240V AC, 50/60Hz

Related product manuals