DD+DIS155
.11E
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
1 Introduction
IMPORTANT:
This document describes the installation and configuration of the digitizer including the
NX workstation with the help of the Quick Installation Guide (part of delivery) and the
CR 10-X / CR 12-X configuration wizard.
For installation without using the CR 10-X / CR 12-X configuration wizard refer to the
appendix, section 5.
REQUIRED TOOLS
The required tools are part of delivery.
REQUIRED TIME:
The complete installation of the digitizer including installation and configuration of the
workstation takes approximately 1 hour.
REQUIRED DOCUMENTS
Chapter 4 of the corresponding NX Workstation version in the Agfa HealthCare Library:
Computed Radiography > CR Workstation Software
NOTE:
The Installation Checklist in section 6 of this chapter gives an overview of all steps
of the digitizer installat
ion and guides through the complete installation process.
2 Installation Preparation
Preparing the installation is split up into the following steps:
# Task Section
1 Check the installation site prerequisites. 2.1
2 Unpack the digitizer. 2.2
3 Unpack the workstation and monitor. 2.3
4 Check the shipment completeness. 2.4
Edition 1, Revision 4 CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 1 / Page 4 of 47
03-2013 Type 5151 / 100 / 110 / 200 / 210 Agfa Company Confidential
To Next Page
