Agilent 1100 Series LC/MSD Trap System Quick Start Guide 7
Step 1—Start the software
The instructions below include the following assumptions:
• The hardware and software are properly installed.
• The instrument is configured. Use instructions in the Agilent 1100 Series
LC/MSD Trap System Installation Guide to configure the instrument for the
first time.
To start the Trap software with the Security software installed, see the G3310AA
LC/MSD Trap Security Pack 1.0 Quick Start Guide.
Start the Trap software on an LC/MSD Trap Control PC
For an online installation, the desktop displays the following icons.
Start the Trap software
• Double-click the Instrument 1 Online icon.
This automatically opens ChemStation, MSD Trap Control and DataAnalysis in
that order.
You open the QuantAnalysis and ScriptStarter programs separately.
ChemStation Controls LC, lets you save and load LC/MS acquisition methods and lets you set up
and run sequences
MSD Trap Control Controls MSD Trap and lets you set up MS part of method
Data Analysis Lets you review qualitative data and search unknowns
QuantAnalysis Lets you set up calibration curves and quantify compounds
ScriptStarter Runs automated data processing for large sequences of data files, normally stored
in the same directory. Automation is possible because a DataAnalysis method,
containing a script, is initially stored with an acquisition method and then
transferred to the data file acquired by the acquisition method. See Chapter 3,
“How LC/MSD Trap Methods Work”, in the Concepts Guide for more information
on how methods are organized.
DataAnalysis ScriptStarter QuantAnalysis Trap Control Instrument 1 Online
To Next Page
Loading...
Need help?
General
