Setting Up the Oscilloscope
To verify basic oscilloscope operation
1-31
5 Move the mouse pointer to the graphical interface enable button and
click once using the left mouse button.
The graphical interface enable button is in the upper-right corner of the display.
6 Move the mouse around and verify that the pointer follows on the
screen.
If the pointer does not move, ensure that the mouse is properly connected, that
you have clicked the correct button to enable the graphical interface, and that
the mouse is on a medium-friction surface.
Figure 1-24
Graphical Interface Enable Button
With the mouse pointer
on the right-hand button,
click the mouse to
enable the graphical
interface
To Next Page
Loading...
