Agilent Technologies 54853A

Chapter 5: Troubleshooting
To install the fan safety shield
5–3
Default Setup
A Default Setup is provided to assure the instrument setup is in a known default state.
The default setup prevents previous setups from interfering with the next test. It also
simplifies the instrument setup procedure. Use the default setup when a procedure
requires it.
• Press the Default Setup key to set the instrument to the default state.
To install the fan safety shield
1 Disconnect the instrument power cord and remove the cover.
,IQHFHVVDU\UHIHUWRWKHSURFHGXUHVLQFKDSWHU5HSODFLQJ$VVHPEOLHV
2 Clip the fan safety shield over the outside of the instrument chassis next to the fans.
6HHILJXUH
Figure 5-1
Installing the Fan Safety Shield