Chapter 6: Replacing Assemblies
To remove and replace the power supply
6–34
6
Remove the Torx T15 screw that secures the power supply support bracket to the power
supply.
7 Remove the two Torx T10 screws that secure the support bracket to the front chassis.
8 If you do not have option 017 (removeable hard disk drive), follow the instructions for
removing the hard disk drive found earlier in this chapter.
If you have option 017 installed, remove the four T15 screws in the side of the power supply.
See Figure 5-33.
9 Separate the main power input cable from the power supply cable to the power supply.
To Next Page
Loading...
Need help?
General
