Chapter 2: Setting Up the Oscilloscope
To connect power
2–4
3
Connect the power cord to the rear of the oscilloscope, then to a suitable ac voltage source
(120-240 VAC ±10%, 47 to 440 Hz, max power dissipation 475 W).
Figure 2-2
Infiniium Oscilloscope Power Cord Connection
The oscilloscope power supply automatically adjusts for line input voltages in the range 120 to 240
VAC. Therefore, you do not need to adjust an input line voltage setting. The line cord provided is
matched by Agilent Technologies to the country of origin of the order. A full list of power cables
and plug configurations is shown in chapter 6, "Replaceable Parts".
To Next Page
Loading...
