Agilent Technologies 5975

51
Agilent 5975 Series MSD
Operation Manual for MassHunter
Agilent Technologies
3
Operating in Electron Impact (EI) Mode
Operating the MSD from the Data System 53
Operating the MSD from the LCP 53
LCP Status Messages 55
LCP Menus 57
The EI GC/MSD Interface 60
Before You Turn On the MSD 62
Pumping Down 63
Controlling Temperatures 63
Controlling Column Flow 64
Venting the MSD 65
To View MSD Temperature and Vacuum in Manual Tune 66
To Set Monitors for MSD Temperature and Vacuum Status 67
To Set Analyzer Temperatures from the Instrument Control View 69
To Set the GC/MSD Interface Temperature from MassHunter 71
To Monitor High Vacuum Pressure 72
To Calibrate Column Flow Linear Velocity 74
To Calibrate Column Flow Linear Velocity 74
To Tune the MSD in EI Mode 77
To Verify System Performance 79
To Perform High-Mass Testing (5975 Series MSDs) 80
To Remove the MSD Covers 83
To Vent the MSD 85
To Open the Analyzer Chamber 88
To Close the Analyzer Chamber 91
To Pump Down the MSD in EI Mode 95
To Move or Store the MSD 97
To Set the Interface Temperature from the GC 99