5977B Series MSD Operating Manual 11
To Assemble the EI XTR Source 188
To Replace a Filament in an EI XTR, SS, or Inert Source 191
To Install the EI XTR, SS, or Inert Source 193
To Replace the Electron Multiplier Horn 194
To Close the Analyzer Chamber 196
7 CI Maintenance
General Information 198
To set up your MSD for CI operation 198
To Switch from the EI HES to the CI Source 199
To Remove the EI HES Radiator 200
To Connect/Disconnect Wiring to the EI HES Radiator 201
To Install the CI Source Radiator 202
To Switch from the CI Source to the EI HES 204
To Remove the CI Source Radiator 206
To Install the EI HES Radiator 208
To Switch from an EI XTR, SS, or Inert Source to the CI
Source 209
To Switch from the CI Source to an EI XTR, SS, or Inert
Source 210
To Remove the CI Source 211
To Connect/Disconnect non-HES Model Wiring from the CI
Source 212
To Connect/Disconnect EI HES Model Wiring to the CI
Source 213
To Disassemble the CI Source 214
To Clean the CI Source 217
To Next Page
Loading...
Need help?
General
