Introduction 1
5977B Series MSD Operating Manual 31
Intended Use
Agilent products must be used only in the manner described in the Agilent
product user guides. Any other use may result in damage to the product or
personal injury. Agilent is not responsible for any damages caused, in whole or
in part, by improper use of the products, unauthorized alterations,
adjustments, or modifications to the products, failure to comply with
procedures in Agilent product user guides, or use of the products in violation
of applicable laws, rules, or regulations.
Cleaning/Recycling the Product
To clean the unit, disconnect the power and wipe down with a damp, lint-free
cloth. For recycling, contact your local Agilent sales office.
Accidental Liquid Spillage
Do not spill liquids on the MSD. If liquid is accidentally spilled on the MSD,
first, cut the power. Once the MSD is disconnected from all power sources, dry
all affected parts. If the liquid spillage affects the electronics, wait at least 24
hours, depending upon the ambient humidity. While waiting for the parts to
dry, please call your local Agilent service representative.
Moving or Storing the MSD
The best way to keep your MSD functioning properly is to keep it pumped
down and hot, with carrier gas flow. If you plan to move or store your MSD,
additional precautions are required:
• The MSD must remain upright at all times; this requires special caution
when moving.
• The MSD should not be left vented to atmosphere for long periods.
To Next Page
Loading...
Need help?
General
