35
Agilent 6400 Series Triple Quadrupole LC/MS System
Installation Guide
2
Software Installation and Configuration
Step 1. Set up the computer system 36
Step 2. Check PC network card configuration 37
Step 3. Prepare for installation 38
Step 4. Install the Data Acquisition program 39
Step 5. Install the Qualitative Analysis program 40
Step 6. Install the Quantitative Analysis program 41
Step 7. Install Microsoft Excel (optional) 41
Step 8. Install Service Packs for Data Acquisition 41
Step 9. Install Quantitative Analysis Reporting 42
Step 10. Configure Excel for MassHunter (optional) 42
Step 11. Configure the instrument 42
Step 12. Copy the support folder to the computer 44
Step 13. Confirm the LC firmware revision 46
Step 14. Finish the installation 47
If you purchased a bundled Triple Quadrupole LC/MS system, the MassHunter
Workstation software has been installed for you. In this case, start at “Step 4.
Install the Data Acquisition program”.
If you are upgrading MassHunter software that is already installed, refer to
the Upgrade Guide that came with your system.
To Next Page
Loading...
Need help?
General
