Agilent Technologies 708-DS User Manual

Setting Up the 708-DS / 709-DS 3
708-DS / 709-DS Operator’s Manual 29
Temperature Probe Installation (708-DS)
1 Insert the water bath temperature probe into the BATH TEMP jack
on the rear of the dissolution apparatus drive unit.
Figure 8 BATH TEMP Connector
2 Place the other end of the temperature probe through the hole in the
center of the vessel plate in the water bath.
Figure 9 Positioning the Temperature Probe

Agilent Technologies 708-DS Specifications

General

Brand	Agilent Technologies
Model	708-DS
Category	Laboratory Equipment
Language	English