Installation Guide
Connecting The Cabling
9
Figure 8 7683 Automatic Liquid Sampler cabling for 6850
2. When the cables are connected, turn on the GC power. The tray will beep
twice. After the start-up process ends, the Ready light on the injector tower
should be on.
If the Align Mode light is on, see Turret alignment on page 16.
If either the Fault or Run light is on, see Faults on page 25.
Injector
Injector cable
6850 GC
Connect to top
connector only
To Next Page
Loading...
