Installation Guide
Installation Checklist
1
Installation Checklist
The 7683 Automatic Liquid Sampler consists of the G2612A ALS Interface Board,
the G2613A Injector Module, the optional G2614A Tray, and an optional G1926A
Bar Code Reader for the tray. The tray and ALS interface board are installed only
on the 6890 Plus Gas Chromatograph (GC).
Use this checklist when installing your 7683 Automatic Liquid Sampler and
accessories.
❐ Unpack the sampler components.
❒ Install the ALS Interface Board, if purchased.
❒ Install the tray, if purchased. See page 2.
❒ Install the injector mounting post. See page 4.
❒ Install the injector. See page 4.
❒ Install the (8 sample position) turret, if desired. See page 17.
❒ Install the bar code reader, if purchased. See page 6.
❒ Connect the cables. See page 8.
❒ When using the injector for cool on-column injection:
a. Check that the correct needle support assembly is installed. See
page 11.
b. Install the proper syringe for your column. See your Operation Guide.
❒ Configure your GC. See page 12.
❒ Test the installation by performing a trial run. See page 13.
To Next Page
Loading...
Need help?
General
