14 Advanced User Guide
2 Programming
FINAL DRAFT - 8 AUG 2016
Editing events in the run table
1 Press [Run Table].
2 Move the cursor to the event you want to change.
3 To edit the time for an event, move the cursor to the line
labeled Time:. Type the desired time and press [Enter].
4 To edit a setpoint value, scroll to the setpoint line. Press
[On/Yes] or [Off/No] or enter a numeric value for the
setpoint. Press [Enter].
Deleting run time events
1 Press [Run Table].
2 From within this table press [Delete] to delete events from
the run time table. You will be asked to confirm the deletion.
3 Press [On/Yes] to delete the current timed event; press
[Off/No] to cancel this operation.
4 To delete the entire table, press [Delete][Run Table].
To Next Page
Loading...
Need help?
General
