Advanced User Guide 3
Contents
1 Software Keypad
Using the Software Keypad 10
2 Programming
Run Time Programming 12
Using run time events 12
Programming run time events 13
The run table 13
Adding events to the run table 13
Editing events in the run table 14
Deleting run time events 14
Clock Time Programming 15
Using clock time events 15
Programming clock time events 15
Adding events to the clock table 15
Editing clock time events 16
Deleting clock time events 16
Post Run Programming 17
To enable a post run program 17
To disable a post run program 17
3 Inlets
Using Hydrogen 20
Inlet Overview 21
Carrier Gas Flow Rates 22
About Gas Saver 23
To use gas saver 24
Pre Run and Prep Run 25
The [Prep Run] key 25
Auto Prep Run 26
About the Split/Splitless Inlet 27
Septum tightening (S/SL) 27
Standard S/SL inlet 28
Split/Splitless inlet split mode overview 28
Split/Splitless inlet splitless mode overview 29
The S/SL inlet pulsed split and splitless modes 30
Split/Splitless inlet split mode minimum operating pressures 31
To Next Page
Loading...
Need help?
General
