Agilent InfinityLab LC Series Vialsamplers User Manual 191
7Error Information
Agilent Lab Advisor Software
Sample Cooler/Sample Thermostat Error Messages 213
Sample temperature control voltage too low, check fuses and wires 213
Sample temperature control switched off due to condensate 213
Sample temperature control switched off due to overpressure 214
Sample temperature control sensor electronics calibration failed 214
Sample temperature control switched off due to supply voltage drop 215
Cooler condensate sensor defect 215
Cooler PCB is in error mode 215
Cooler condenser fan failed 216
Thermostat communication error 216
Heater defect 216
Heater in operating error 217
Thermostat sensor defect 217
Compressor has error 217
Sample Thermostat unknown 218
Thermostat fan defect 218
Integrated Column Compartment (ICC) Heater Error Messages 219
Wait for temperature function timed out 219
Heater over-current protection active 219
A heater sensor reading failed 220
Trend analysis for the heater temperature sensors failed 220
Maximum heater temperature exceeded 221
Column heater not connected 221
This chapter describes the meaning of error messages, and provides information
on probable causes and suggested actions how to recover from error conditions.
To Next Page
Loading...
Need help?
General
