Agilent Technologies G7129B User Manual

Agilent InfinityLab LC Series Vialsamplers User Manual 340
12 LAN Configuration
Dynamic Host Configuration Protocol (DHCP)
2 Set the configuration switch to DHCP either on the G1369C LAN Interface
Card or the mainboard of above mentioned modules.
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition, Lab
Advisor, Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note in
section
“General Information (DHCP)” on page 338).
Table 29 G1369C LAN Interface Card (configuration switch on the card)
SW 4 SW 5 SW 6 SW 7 SW 8 Initialization Mode
ON OFF OFF OFF OFF DHCP
Table 30 LC Modules with 8-bit configuration switch (B-firmware) (configuration switch at rear
of the instrument)
SW 6 SW 7 SW 8 Initialization Mode
ON OFF OFF DHCP

Agilent Technologies G7129B Specifications

General

Brand	Agilent Technologies
Model	G7129B
Category	Laboratory Equipment
Language	English