Agilent Technologies MSD 5977B Series User Manual

5977B Series MSD Operating Manual 221
8 CI Maintenance
General Information 222
To Switch from the EI HES to the CI Source 223
To Remove the EI HES Radiator 224
To Connect/Disconnect Wiring to the EI HES Radiator 225
To Install the CI Source Radiator 227
To Switch from the CI Source to the EI HES 229
To Remove the CI Source Radiator 230
To Install the EI HES Radiator 232
To Switch from an EI XTR, SS, or Inert Source to the CI Source 233
To Switch from the CI Source to an EI XTR, SS, or Inert Source 234
To Remove the CI Source 235
To Connect/Disconnect non-HES Model Wiring from the CI Source 236
To Connect/Disconnect EI HES Model Wiring to the CI Source 237
To Disassemble the CI Source 238
To Clean the CI Source 241
To Assemble the CI Source 244
To Remove the CI Source Filament 247
To Install a CI Source Filament 249
To Install the CI Source 250
This chapter describes maintenance procedures and requirements that are unique
to 5977B Series MSDs equipped with the CI hardware.
If you are using the Agilent Intuvo 9000 Gas Chromatograph with your MSD,
Chemical Ionization (CI) is not currently supported.

Agilent Technologies MSD 5977B Series Specifications

General

Brand	Agilent Technologies
Model	MSD 5977B Series
Category	Water Pump
Language	English