8CI Maintenance
To Remove the EI HES Radiator
224 5977B Series MSD Operating Manual
To Remove the EI HES Radiator
Materials needed
• Gloves, clean, lint-free
• Large (8650-0030)
• Small (8650-0029)
• Tweezers (8710-2460)
• T10 Torx screwdriver (5182-3466)
Procedure
1 Remove the EI HES. (See“To Remove the EI HES” on page 178.)
2 Disconnect the wires from the EI HES radiator. (See“To Connect/Disconnect
Wiring to the EI HES Radiator” on page 225.)
3 Use a T10 Torx screwdriver to loosen the 2 screws that secure the radiator to
the analyzer, and place the radiator in its storage container.
The analyzers, GC/MSD interface, and other components in the analyzer
chamber operate at very high temperatures. Do not touch any part until you
are sure it is cool.
• Always wear clean gloves to prevent contamination when working in the
analyzer chamber.
• Make sure you use an antistatic wrist strap and take other antistatic
precautions before touching analyzer components.
• When disconnecting leads, pull on the connectors, not on the wires
To Next Page
Loading...
Need help?
General
