3
46 AhnLab TrusGuard Installation Guide
System Settings
Specify the settings to connect the network to the sysetm.
Default Settings
TrusGuard’s default system settings are as below:
Admin ID: (Please ask AhnLab)
Password: (Please ask AhnLab)
Administrative IP Address: 10.0.0.0/16 (IP address allowed to access the device)
IPv4 Address: 10.0.N.254/24 (N is the number allotted to the network port. E.g.: eth0, eth1, ... ethN)
IPv6 Address: Not allotted
Before System Settings
Before setting the system, check below:
Internet connection
PC or laptop that meets the administrative system requirements
Product license
Power
To Next Page
Loading...