3
Chapter3 Installation 85
Set Local TrusAnalyzer
If you are using a device with a hard disk, you can run TrusAnalyzer from the local system.
Before
using a local TrusAnalyzer, check the local server settings.
Log in
to SSH or the console terminal.
If you
use TrusAnalyzer in a device using HA mode, the performance may decline, use a separate
TrusAnalyzer.
The local TrusAnalyzer can
manage up to two devices including itself.
Step 1: Check TrusAnalyzer Status
1 Type admin and press the Enter key to enter admin mode.
2 Type get_atlli
t and press the Enter key to check whether TrusAnalyzer is running.
• If the re
sult is 1, TrusAnalyzer is running and you need to stop TrusAnalyzer settings.
• If the re
sult is 0, TrusAnalyzer is not running. Move on to Step 2.
Step 2: Set TrusAnalyzer and Restart System
1 Type set_atllite 1 and press the Enter key.
2 Type apply and press the Enter key.
3 Type ex
it and press the Enter key to enter admin mode.
4 Type system and press the
Enter key to enter ssytem mode.
5 Type reboot
and press the Enter key.
• When the
login prompt, id:, appears, type the administrator’s ID.
• When the
password prompt, passwd:, appears, type the password.
The hard disk has been formatted to
recognize TrusAnalyzer. If you change the hard disk, it will get
formatted whilte booting, and take a long time.
Step 3: Log in to TrusAnalyzer
There are two ways to log in to TrusAnalyzer.
Single Sign-On from TrusGuard
Click TrusAnalyzer in TrusGuard.
To Next Page
Loading...