3
Chapter3 Installation 65
Bridge
Use bridge interface when you cannot change the network setting.
When you install TrusGuard at the
bottom of the router, and the router and the bottom network
must use the same network address
When the
cable modem operates as DHCP and the bottom network host must use DHCP
Bridge and aggregation are similar,
but its use is different.
Set Bridge Interface
Set the bridge interface as below. Use the default settings for any fields that have been left out.
1 In the profile/poli
cy modification tool, click .
2 Add Network Interface will ap
pear. Specify the settings as below.
To Next Page
Loading...