3
Chapter3 Installation 77
4 Click OK.
5 Click Apply.
Multi-Path Routing
When using multiple network interfaces in the same bandwidth, more than two routing paths with the
same priority can be used. When a problem occurs in a specific service in equal-cost multi-path
environment, the problem can be sovled by changing the Load Balancing.
1 From the menu, go to Network > Routing > Multipath Routing.
2 The Multipath Routing Settings window will appear. Select Load Balancing (Per session, Per
source IP).
• Per session: Specifies routing path per session.
• Per source IP: Specifies routing path per source IP.
3 Click OK.
4 Click Apply.
Per session is only available while the session is active.
Note
When there are more than two gateways, use the set_gw_check command in the terminal to set to
check the gateway status. When a problem occurs in the gateway, do not use the line until it is
completely repaired.
To Next Page
Loading...