AhnLab TrusGuard - Secondary Port

To Next Page

To Previous Page

Chapter3 Installation 69

• Enter the IPv6 address.

• Select the respo

nse protocol in Control.

▪ PING: To respond

to ICMP ping requests

▪ HTTP

S: To allow access to administrative web page

▪ SSH: To all

ow connection to SSH terminal

▪ ARP

: To allow resolution of network layer addresses into link layer addresses

▪

NDP: To allow the operation in the link layer of the Internet model, and address autoconfiguraiton.

3 Click OK.

4 Click App

ly.

Secondary Port

Secondary port is used in HA mode, when setting services that use TrusGuard’s IP address.

Set Secondary Port

Set the secondary port as below. Use the default settings for any fields that have been left out.

1 In the profile/poli

cy modification tool, click .

2 Add Network Interface will ap

pear. Specify the settings as below.