AhnLab TrusGuard - Register Administrative IP Address

3
Chapter3 Installation 79
Register Administrative IP Address
Restrict the IP addresses that can access TrusGuard’s administrator web page. If not, it will be open to
attack.
Step 1: Check Administrative Network Interface
Step: Network > Interface > Interface
Before registering the administrative IP addres
s, select the interface for the administrator to use to
access TrusGuard. It is advisable to keep the administrator’s network interface separate from other
interfaces
1 Se
lect the interface from the list.
• There should
be an IP address for the interface.
2 Check the Control opti
on.
• To
allow access to the administrator’s web page, HTTPS should be displayed.
• To al
low connection to SSH terminal, SSH should be displayed.
• If
both HTTPS and SSH are not displayed, double click the interface or select ( ) it, and click .
Then, modify Control.
3 Click OK.
4 Click App
ly.
Step 2: Register Administrative IP Address
Step: System > Administrator > Administrative IPv4 Address / Administrative IPv6 Address
Register the IPv4 and IPv6 address of the administrator’s h
ost to allow access to the administrator’s
web page.
1 To ad
d an administrative IP address, click . To modify an IP address that is already registered,
double click the IP address or select (
) it. Then, click .
2 Specify
the settings.
• En
ter the IP Address to allow.
• Enter a descript
ion of the IP address.
3 Click OK.
4 Click App
ly.