HM135/HM435 Programmer software guide
Preliminary version Page 4
1 ABOUT THIS MANUAL
1.1 Warning notes
Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. CTE
International assumes no responsibility for the results of errors beyond its control. The manufacturer of this equipment also
cannot guarantee that changes in software and equipment made by non authorized people and referred to in this guide will
not affect the applicability of the information in it.
Only authorized and qualified technicians should be allowed to follow the operation described into this manual.
This manual has been written for use by CTE International dealers and distributors who are programming the HM135/HM435
mobile transceivers for customers. You should be familiar with conventional radio systems, radio system and radio network
settings parameters as well as general PC operation.
This programming guide is subject to change without notification. This booklet is referred to the current software version
1.065. If you own a later one please surf on www.cte.it
or contact CTE International for the most recent updates by sending
an email at webmaster@cte.it.
1.2 Conventions and Symbols in this Book
1.2.a Notes and warnings
This symbol marks a ‘note’. Notes are hints or tips which offer additional information to help you.
This symbol marks a ‘warning’. Warnings are special notices which you should read and follow carefully to
avoid possible damage to your equipment, potential danger to yourself or others.
1.2.b Font format
• Window names and screen buttons will be highlighted in bold
• Important sentences and words are highlighted in Italic
• Messages which appear on the display are highlighted with this font (courier New)
1.2.c Screenshots
All the screenshots are normally referred to Windows XP (IT version)
To Next Page
Loading...
