Alcatel-Lucent 7210 SAS M - Page 128

Command Reference
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 123
TDM Commands
Note: TDM commands are applicable only for 7210 SAS-M network mode.
config
— [no] port {port-id}
— tdm
— buildout short
— [no] ds1
— [no] channel-group channel-group
— [no] description long description-string
— [no] encap-type {cem}
— idle-cycle-flag {flags | ones}
—no idle-cycle-flag
— idle-payload-fill {all-ones}
— idle-payload-fill pattern pattern
—no idle-payload-fill
— idle-signal-fill {all-ones}
— idle-signal-fill pattern pattern
—no idle-signal-fill
— [no] mode {access}
— [no] shutdown
— timeslots timeslots
—no timeslots
— clock-source {loop-timed | node-timed | adaptive}
— framing (DS-1) {esf | sf | ds1-unframed}
— loopback {line | internal| fdl-ansi | fdl-bellcore | payload-ansi}
—no loopback
— [no] remote-loop-respond
— [no] report-alarm [ais] [los] [oof] [rai] [looped]
— [no] shutdown
— signal-mode {cas}
— [no] e1 [e1-id]
— [no] channel-group channel-group-id
— description long description-string
—no description
— [no] encap-type {cem}
— idle-payload-fill {all-ones}
— idle-payload-fill pattern pattern
—no idle-payload-fill
— idle-signal-fill {all-ones}
— idle-signal-fill pattern pattern
—no idle-signal-fill
— [no] mode {access}
— [no] shutdown
— timeslots timeslots
—no timeslots
— clock-source {loop-timed | node-timed | adaptive}
— framing (E-1) {no-crc-g704 | g704 | e1-unframed}
— loopback {line | internal}
—no loopback
— [no] report-alarm [ais] [los] [oof] [rai] [looped]
— [no] shutdown
—no signal-mode {cas}