Alcatel-Lucent 7210 SAS M - Page 132

Command Reference
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 127
Ethernet Ring Commands
config
— eth-ring ring-id
—no eth-ring
—[no] ccm-hold-time {down down-timeout | up up-timeout}
— [no] compatible-version version
— description description-string
—no description
—[no] guard-time time
—[no] revert-time time
— [no] rpl-node {owner | nbr}
—[no] node-id mac
— [no] sub-ring {virtual-link | non-virtual-link}
— [no] interconnect {ring-id ring-id | vpls}
— [no] propagate-topology-change
—[no] path {a | b} [{ port-id | lag-id } raps-tag qtag[.qtag] ]
— description description-string
— [no] rpl-end
— eth-cfm
— [no] mep mep-id domain md-index association ma-index
— [no] ccm-enable
— [no] ccm-ltm-priority priority
—[no] control-mep
—[no] control-sap-tag tag-range (Supported only on 7210
SAS-X and SAS-R6 and SAS-R12)
— [no] description description-string
— [no] eth-test-enable
— [no] test-pattern {all-zeros | all-ones} [crc-enable]
— bit-error-threshold bit-errors
— low-priority-defect {allDef|macRemErrXcon|remErrX-
con|errXcon|xcon|noXcon}
— mac-address mac-address
— one-way-delay-threshold seconds
— [no] shutdown
— [no] shutdown