Port Show Commands
Page 258 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
SONET — The port is configured as SONET-SDH
MTU
The size of the largest packet which can be sent/received on the Ether-
net physical interface, specified in octets.
Admin State
Up — The port is administratively up.
Down — The port is administratively down.
Oper State
Up — The port is operationally up.
Down — The port is operationally down.
Duplex
Full — The link is set to full duplex mode.
Half — The link is set to half duplex mode.
Hold time up
The link up dampening time in seconds. The port link dampening timer
value which reduces the number of link transitions reported to upper
layer protocols.
Hold time down
The link down dampening time in seconds. The down timer controls
the dampening timer for link down transitions.
IfIndex
Displays the interface's index number which reflects its initialization
sequence.
Phy Link
Yes — A physical link is present.
No — A physical link is not present.
Configured Mode
network — The port is configured for transport network use.
access — The port is configured for service access.
Network Qos Pol
The network QoS policy ID applied to the port.
Encap Type
Null — Ingress frames will not use any tags or labels to delineate a
service.
dot1q — Ingress frames carry 802.1Q tags where each tag signifies
a different service.
QinQ — Encapsulation type specified for QinQ Access SAPs.
Active Alarms
The number of alarms outstanding on this port.
Auto-negotiate
True — The link attempts to automatically negotiate the link speed
and duplex parameters.
False — The duplex and speed values are used for the link.
Alarm State
The current alarm state of the port.
Label Description (Continued)
To Next Page
Loading...
