Card, Adapter Card, and Port Command Reference
Page 122 7705 SAR OS Interface Configuration Guide
For access mode, the supported encapsulation types are cem, atm, and ipcp. For network mode, only
ppp-auto encapsulation is supported. The ppp-auto encapsulation type does not support fractional
DS1 or E1.
Default cem
Parameters atm — specifies the encapsulation type as atm for ATM pseudowires
cem — specifies the encapsulation type as circuit emulation mode for TDM pseudowires
ipcp — specifies the encapsulation type as IPCP for a PPP/MLPPP channel group in access mode
ppp-auto — specifies the encapsulation type as PPP for PPP/MLPPP bundles in network mode
idle-cycle-flag
Syntax idle-cycle-flag {flags | ones}
no idle-cycle-flag
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command configures the value that the DS0, DS1, or E1 interface transmits during idle cycles.
This command is applicable only if the encapsulation type is ppp-auto.
The no form of this command changes the idle cycle flag to the default value.
Default flags (0x7E)
Parameters flags — use 0x7E as the idle cycle flag
ones — use 0xFF as the idle cycle flag
idle-payload-fill
Syntax idle-payload-fill {all-ones | pattern pattern}
no idle-payload-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the data pattern to be transmitted (8-bit value) when the circuit emulation
service is not operational or temporarily experiences underrun conditions. This command is only
valid for CESoPSN services.
Default all-ones
Note: See the 7705 SAR OS Services Guide for information on CESoPSN services.
To Next Page
Loading...
