3 Maintain the ATCA Subrack
x is 3 for JBXOMCP1
x is 4 for JBXOMCP2.
9. If the disable/lock operation was successful during JBXOMCP board
removal, from BSC terminal or OMC-R initialize/unlock the corresponding
JBXOMCP board.
The blue LED is switched OFF.
If the disable/lock operation was unsuccessful during JBXOMCP board
removal, continue with step 11.
10. With the new OMCP terminal window connection through SHMC selected,
press [ F12 ] several times from the Local PC keyboard. This action will
force the new JBXOMCP board to boot from the existing JBXOMCP board
and it must be done during the new JBXOMCP board booting sequence.
Help: If this forced boot by pressing [ F12 ] doesn’t work and you have to enter in
the BIOS settings of the new JBXOMCP board.
To enter in the BIOS settings, press [ ESC ] + [ 2 ] several times from the
keyboard during the new JBXOMCP booting sequence.
To force the new JBXOMCP board to boot from the existing JBXOMCP board:
From "BIOS Setup Utility" window, use the arrow keys to navigate to the
Boot menu.
From Boot menu, use the arrow keys to select ’Hard Drive’ then press [ ! ]
to disable hard disk drive option.
Press [ F10 ] and then press [ Enter ] to save the changes you made
and exit the BIOS.
When the new JBXOMCP board is starting to boot up from the existing
JBXOMCP board the following message should appear:
CLIENT IP: 172.17.3.x MASK: 255.255.0.0 DHCP IP:
172.17.3.y
PXELINUX 2.05 2003-07-16 Copyright <C> 1994-2003 H.
Peter Anvin
when new JBXOMCP board is JBXOMCP1:
x is 160
y is 40.
when new JBXOMCP board is JBXOMCP2:
x is 161
y is 30.
Harddisk Installation will take about 10 minutes.
11. In the terminal window connection through SHMC the following messages
should appear:
Harddisk Installation Complete
The Blade is going to reboot
Do not forget to disable the network boot
Option in the Bios settings if needed.
Type "go" and press "return" key to continue.
go
3BK 21281 AAAA PCZZA Ed.13 39 / 90
To Next Page
Loading...
