Allen-Bradley 193-DNENCAT - Wiring and Diagrams

14 Rockwell Automation Publication 193-UM014C-EN-P - August 2016
Chapter 1 Installation and Wiring
Figure 2 - Installation
Wiring
The EtherNet/IP Communication Auxiliary Module can accept all forms of
DeviceNet cable. However, DeviceNet shielded cable is recommended. The
module complies with the Open Device Vendors Association (ODVA)
DeviceNet compliance testing when the distance between end nodes is 100 m
or less with 60 or fewer network drops.
Table 1 - Wire and Torque Specifications
Front View
37.44 mm
(1-1/2 in.)
37.44 mm
(1-1/2 in.)
Wire Torque
1X
2X
24…12 AWG
24…16 AWG
5 lb.•in.
1X
2X
0.2…2.5 mm
2
0.25…1 mm
2
0.56 N•m
1X
2X
0.2…2.5 mm
2
0.2…1 mm
2
0.56 N•m