Rockwell Automation Publication 193-UM014C-EN-P - August 2016 33
Configure the EtherNet/IP Communication Auxiliary Module Chapter 2
EtherNet/IP communication auxiliary module back to their original position
and cycle power. The EtherNet/IP Communication Auxiliary Web Server will
be disabled unless it was permanently enabled.
Permanently Enabling the Web Server
In Administrative Mode, you can change any configuration parameter of the
EtherNet/IP communication auxiliary module, including permanently
enabling the embedded web server by following these steps:
1. Enter Administrative Mode by turning the rotary dials to 000 and cycle
power on the EtherNet/IP communication auxiliary module
2. Access the web page
3. Navigate to Administrative Settings->Network Configuration
4. You will be prompted for a user name and password. The default user
name is Administrator, and the default password is <blank>. Enter
“Administrator” as the user name, and leave the “password” field blank as
shown in the following picture.
5. Enable the Web Server Control and press “Apply Changes”.
To Next Page
Loading...
