Allen-Bradley 193-DNENCAT - Adding to Scan List

44 Rockwell Automation Publication 193-UM014C-EN-P - August 2016
Chapter 4 Add Devices to the DeviceNet Network
6. In the 'New settings' section, verify that the node address was changed to
the desired value.
Note that the 'Current settings' area still displays the old node address
until you select the device again from the Network Who list.Verify the
node address was changed to the desired value in the “New settings”
section of the page. Note that the “Current settings” area still displays
the old node address until you select the device again from the Network
Who list.
7. Repeat steps 1
… 6 until all new or additional devices are added to the
Device Network.
Add DeviceNet Modules to
the Scan List
After each DeviceNet device has been assigned a unique node address, you can
add up to six DeviceNet devices to the EtherNet/IP communication auxiliary
module DeviceNet scan list. The EtherNet/IP communication auxiliary
module provides two methods to configure the scan list, Simple and User-
Defined.