Rockwell Automation Publication 193-UM014C-EN-P - August 2016 77
Email/Text Chapter 8
If desired, you can set a password within the Administrative Settings tab.
4. Type the information into the email notification fields as shown.
5. Check the desired notification time, fault conditions, and local
conditions to be included in notification emails to the recipient. You can
change these values after the initial configurations.
6. Click Apply Changes to save the configuration.
Configure Device Identity
The properties of the Device Identity populate the notification email subject
and email body. To configure the Device Identity, perform the following steps.
1. Select Administrative Settings>Device Identity.
Email Recipient The email address of the person who receives the notifications.
Email Sender The email address from which the notification is sent.
SMTP Server Consult with the network administrator for the SMTP server address.
SMTP Username Consult with the network administrator for the SMTP username.
SMTP Password Consult with the network administrator for the SMTP password.
SMTP Port
Consult with the network administrator which SMTP port number to use. Port 25 is the
most common SMTP port.
To Next Page
Loading...
