Rockwell Automation Publication 193-UM014C-EN-P - August 2016 35
Chapter 3
Configure the DeviceNet Network
Introduction
This chapter helps you to configure the DeviceNet Network by using the
EtherNet/IP communication auxiliary module. You can configure a DeviceNet
network by using the internal web interface from the EtherNet/IP
communication auxiliary module.
Configuration
1. Enable the EtherNet/IP Communication Auxiliary Web Server
(page 33
). Using a web browser, navigate to the menu on the left and
choose Scan List>Configuration>Advanced.
2. If desired, change the baud rate using the DeviceNet Baud Rate pull-
down menu. The default value of 125K for the DeviceNet network.l
NOTE: Autobaud is not supported with this product.
To Next Page
Loading...
