54 Rockwell Automation Publication 193-UM014C-EN-P - August 2016
Chapter 6 Automatic Device Recovery or Replace
By default, the Device Type, Vendor, and Product Code are enabled.
Electronic keying defines how closely a replacement device must match a
failed device before the EtherNet/IP Auxiliary reconfigures a module. If
the new module does not match the criteria of one of the checked boxes,
the ADR does not function and an ADR error appears.
3. Once the scan list and DeviceNet module programmable parameters
have been configured, click Upload ADR Data.
The EtherNet/IP communication auxiliary module upload and stores
the configuration data from the modules in the scan list and a
confirmation message appears.
4. Select Enable from the Auto Device Replace pull-down menu. This
enables the ADR.
To Next Page
Loading...
