Rockwell Automation Publication 5069-UM004A-EN-P - April 2019 173
Configure a Standard Module   Chapter 6
Events Category
The Events category is available only if you choose Data with Events for 
Connection in the Module Definition dialog box. Click the + sign next to the 
Events category to expand it.
The Events subcategories show the configuration parameters for events.
IMPORTANT You cannot configure events on the Module Properties dialog box. The 
parameters that are displayed are read-only. 
You must use the Event Output tags to configure an event. For more 
information, see 
Configure an Event in the Event Output Tags on page 174.