60 Rockwell Automation Publication 5069-UM004A-EN-P - April 2019
Chapter 1 Digital Module Operation in a Control System
Use with Safety Controllers
You can only use the Compact GuardLogix 5380 or GuardLogix 5580
controllers with the Compact 5000 I/O safety modules. Restrictions apply
regarding how the controllers can use the I/O modules. The restrictions are
described in
Controller and Software Compatibility on page 18.
For more information on which controllers you can use with Compact 5000
I/O safety modules, see
Table 3 on page 19.
You must use the Logix Designer application, version 32 or later, to configure
the Compact 5000 I/O safety modules.
Determine Conformity
ATTENTION: Use only appropriate components or devices that comply with
the relevant safety standards and meet the required safety integrity level or
Performance Level and safety category.
• Conformity to the requirements of the relevant safety standards must be
determined for the entire system by conducting a risk assessment.
• Use devices properly according to the installation environment,
performance rating, and functions of the machine.
• Use devices within their specified ratings.
• We recommend that you consult a certification body regarding assessment
of conformity to the required safety integrity level or Performance Level.
You are responsible for confirming compliance with the applicable standards for
the entire system. You must read, understand, and fulfill the functional safety
requirements of the standard applicable to your safety application.
To Next Page
Loading...
