186 Rockwell Automation Publication 5069-UM004A-EN-P - April 2019
Chapter 6 Configure a Standard Module
Edit 5069-OW4I Module
Configuration Categories
In addition to the General, Connection, and Module Info categories, the
Points category is available when you configure a 5069-OW4I module.
Points Category
The Points category shows the configuration options available for each point.
You can configure the following parameters from the Points category:
• Output State During Program Mode
• Output State During Fault Mode
• Fault Mode Output State Duration
• Fault Mode Output State Final State
• Output State When Communications Fail in Program Mode
IMPORTANT If you use the Listen Only connection type, the Points Category does
not appear.
To Next Page
Loading...
