Allen-Bradley 5069-IB16 - Configure the Modules; Connections with Compact 5000 I;O Digital Modules

40 Rockwell Automation Publication 5069-UM004A-EN-P - April 2019
Chapter 1 Digital Module Operation in a Control System
Configure the Modules
You must create a Logix Designer application project for the controller that
owns the Compact 5000 I/O digital modules. The project includes module
configuration data for the module.
The Logix Designer application transfers the project to the owner-controller
during the program download. Data is then transferred to the I/O modules
either across the backplane or over an EtherNet/IP network.
The I/O modules can operate immediately after receiving the
configuration data.
Connections with Compact 5000 I/O Digital Modules
During module configuration, you must define the module. Among the
Module Definition parameters with Compact 5000 I/O digital modules, you
must choose a connection type for the module. A connection is a real-time data
transfer link between the owner-controller and the module that occupies the
slot that the configuration references.
When you download module configuration to a controller, the controller
attempts to establish a connection to each module in the configuration.
5069-OBV8S
SIL2 CPU
5069-L3100ERMS2
Compact GuardLogix
5069-OBV8S
5069-IB8S5069-IB8S
OUTPUT OUTPUT
SA Power MOD Power
DC INPUT
5069-IB16
DC OUTPUT
5069-OB16
ANALOG INPUT
5069-IY4
SA Power MOD Power
ANALOG OUTPUT
5069-OF8
DC INPUT
5069-IB16
Standard Modules
Safety Modules
™
NET B1
LINK B1
NET A1
LINK A1
NET A2
LINK A2
SPEED X1
LINK X1
OK
RUN
FORCE
FAN 1
SD
FAN 2
CompactLogix 5480
B1
A1
1
2
A2
5069-L46ERMW
CONTROLLER
UPS
MP
SA
R
B
F
R
B
F
DC INPUT
5069-IB16
DC OUTPUT
5069-OB16
ANALOG INPUT
5069-IY4
ANALOG OUTPUT
5069-OF8
DC INPUT
5069-IB16
IMPORTANT This section shows some Logix Designer application screens; it is not a
complete description of how to configure a module.
• For more information on how to use the Logix Designer application to
configure Compact 5000 I/O standard modules, see Chapter 6,
Configure
a Standard Module on page 149.
• For more information on how to use the Logix Designer application to
configure Compact 5000 I/O safety modules, see Chapter 7,
Configure
and Replace Safety Modules on page 191.