Rockwell Automation Publication 5069-UM004A-EN-P - April 2019 195
Configure and Replace Safety Modules Chapter 7
4. You can click OK to use the default configuration as shown or edit the
module configuration. The rest of this chapter describes how to edit
module configuration categories.
To add additional remote I/O modules with this method, complete one of
the following:
• If you cleared the Close on Create checkbox when you created the first
I/O module, repeat steps
3…4.
• If you did not clear the Close on Create checkbox when you created the
first I/O module, repeat steps
2…4.
To Next Page
Loading...
