Rockwell Automation Publication 2097-UM002D-EN-P - April 2017 57
Connect the Kinetix 350 Drive System Chapter 4
Voiding of CE Compliance
The three-phase and neutral in-line filter applications that are described Three-
phase Power Wired to Single-phase Drives on page 55 are not adequate for CE
compliance for EMC. Therefore, EMC validity and CE marking by Rockwell
Automation is voided when three-phase and neutral in line filters are used.
ATTENTION: The three-phase isolation transformer and neutral in-line filter
applications that are described in this document have not been tested for
EMC by Rockwell Automation. The products that are used in such
installations are not considered CE marked by Rockwell Automation.
If this three-phase isolation transformer and neutral in-line filter application is
used, the responsibility for EMC validation lies with the user and CE marking of
the system becomes your responsibility.
If CE compliance is a customer requirement, use single-phase line filters that
Rockwell Automation has tested and are specified for the product. See Kinetix
Servo Drives Specifications Technical Data, publication KNX-TD003
for catalog
numbers.
To Next Page
Loading...
Need help?
General
