Rockwell Automation Publication 2097-UM002D-EN-P - April 2017 77
Chapter 5
Configure and Start up the
Kinetix 350 Drive System
Topic Page
Keypad Input 78
Configure the Kinetix 350 Drive Ethernet IP Address 81
Configure the Logix5000 EtherNet/IP Controller 84
Apply Power to the Kinetix 350 Drive 93
Test and Tune the Axes 94
Disable EnableInputChecking by Using a Logix Designer Message Instruction 100
TIP Before you begin make sure that you know the catalog number for the
drive, the Logix5000™ controller, and the servo motor/actuator in your
motion control application.
To Next Page
Loading...
