Allen-Bradley PowerFlex 755 User Manual

90 Rockwell Automation Publication MOTION-UM003K-EN-P - January 2019
Chapter 4 Configure Integrated Motion Control Using Kinetix 5700 Drives
5. Choose a Loop Response, if applicable.
6. Choose a Converter Configuration, if applicable.
7. Choose a Converter Startup Method, if applicable.
TIP Loop Response settings also impact the calculations that are made
that can minimize the need for you to perform an Autotune or a
Manual Tune. The loop response impacts the spacing between the
position and velocity loops and the proportional and integral gains.
This response impacts how aggressively a given profile is tracked.
TIP The following General Options are available in an converter configuration.

Allen-Bradley PowerFlex 755 Specifications

General

Category	AC Drive
Amperage	2.2…1470 A
Output Voltage	0 to Input Voltage
Output Current	2.2…1470 A
Enclosure	IP20, IP30, IP54
Communications	EtherNet/IP, ControlNet, DeviceNet
I/O	Digital, Analog, Encoder, Relay
Safety	Safe Speed Monitor
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overload, Short Circuit, Ground Fault, Overtemperature
Operating Temperature	-10°C to 50°C (14°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5…95% noncondensing
Altitude	Up to 1000m (3300ft) without derating
Voltage	200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Control Method	Sensorless Vector