To Next PageTo Next Page
Need help?Do you have a question about the Allsteel Optimize and is the answer not in the manual?
General| Brand | Allsteel |
|---|---|
| Model | Optimize |
| Category | Indoor Furnishing |
| Language | English |
Defines parent panel run and return panels for system stability and space division.
Specifies requirements for suspending overhead storage units on panels.
Details installing corner connectors to join panels at corners.
Explains connecting panels side-by-side using specific hardware.
Describes how to connect panels of different heights.
Instructions for removing and installing kickplates on panels.
Guides on installing trim for variable height panel to corner connections.
Details installing trim for inline variable height panel configurations.
Identifies and lists various types of hardware used in panel connections.
Provides instructions and warnings for stacking panels onto base panels.
Explains how to attach panels to walls using a wall connector.
Critical safety warnings regarding electrical connections and code compliance.
Identifies electrical components and their general configuration for panel systems.
Presents diagrams for single and three-phase electrical wiring configurations.
Shows how to connect power to the final panel in a run.
Demonstrates the procedure for removing a power block.
Guides on how to install and remove electrical receptacles.
Details the installation of in-feed devices at the base or ceiling.
Shows ceiling in-feed installation using an integrated power pole.
Important safety warning about connecting power poles to the power source.
Step-by-step guide for installing the Optimize panel power pole.
Instructions for assembling and attaching full end panel supports, including bracket and worksurface connection.
Details the assembly and installation of support legs for worksurfaces.
Guides on installing center support brackets for longer worksurfaces.
Explains attaching worksurface-to-panel support brackets.
Instructions for installing right-hand and left-hand worksurface brackets.
Details hanging cantilever brackets onto panels.
Instructions for attaching a flat bracket to a return worksurface.
Guides on installing corner support brackets at the rear of corner worksurfaces.
Instructions for installing support columns for peninsula and D-shaped worksurfaces.
Shows positioning of support brackets for countertop installation.
Details positioning and securing countertops with screws.
Directs users to page 1 for general overhead storage guidelines.
Step-by-step guide for attaching overhead shelf units to panels.
Explains how to gang two inline overhead shelf units together.
Instructions for installing 15" H overhead storage cabinets.
Guides positioning overhead storage cabinets onto mounting brackets.
Details securing overhead storage cabinets to mounting brackets.
Instructions for installing the hook plate for sliding doors.
Details installing the hook bracket for sliding doors.
Guides on attaching the bottom rail assembly for sliding doors.
Explains how to attach anti-dislodgement brackets for sliding doors.
Instructions for attaching the top rail assembly for sliding doors.
Details connecting the top rail assembly to anti-dislodgement brackets.
Guides on installing rear door stops and attaching the door to the top track.
Instructions for attaching the sliding door to the bottom track assembly.
Details installing the front door stop for sliding doors.
Guides on cleaning, applying, and securing the sliding door handle.
